Hardware Reference and Operational Manual: RemoteBox
Page 14
SET3: Priority
We can select the default Radio when both Radios select de same Band.
Only one antenna can be connected to one Radio (Radio A or B) so this option will
define which Radio has priority on the antenna in case of a conflict.
These are the available options:
•
Radio A: Antenna will always connect to Radio A (Radio A wins)
•
Radio B: Antenna will always connect to Radio B (Radio B wins)
•
Last Radio: Antenna will connect to the last Radio that was selected.
•
First Radio: The first Radio that selected the antenna has priority.
This option is only available in the “2x” models. (2x6 or 2x8).
If RemoteBox has to reassign an antenna because it is being use by a higher
priority Radio it will automatically connect it to an available antenna.
SET4: Inhibit
The RemoteBox can read via Band Data input which are the band active for each
Radio and it can avoid if this option is enabled that any of the radios will transmit. So
remember you will need to use the band data and activate this option. Then in case
the RemoteBox reads that both radios are at the same band, it will send an Inhibit
signal (see section 1.2)
This option is only available in the “2x” models. (2x6 or 2x8).
Read Annex for cables
SET5: PTT IN
To avoid a hot-switching you can use this option. In this way, the RemoteBox will not
change the antenna relays meanwhile the radio is transmitting.
This option is only available in the “2x” models. (2x6 or 2x8).
Read Annex for cables
SET6: Demo
This option will demo/test the RemoteBox automatically changing antenna and radios
on a set interval.
SET7: USB Port
This option sets the use of the USB port. If RemoteBox is not going to be connected
to a computer it is better to deactivate the USB port.
