7
NOTE: For safety purposes the Docking Base does not have a traditional ON/
OFF switch.
1. Plug the A/C Wall Transformer into an electrical outlet that is powered at all times.
Be sure the outlet is not controlled by a wall switch.
2. Insert the small end connector of the A/C Wall Transformer power cord into the
input labeled POWER on the rear of the Docking Base.
** Follow remaining instructions ONLY if you are installing the Monitored
Docking Base.
3. Disconnect the telephone at its wall jack and reconnect it to the jack labeled
PHONE at the rear of the Docking Base.
4. Insert the supplied telephone line cord into the jack labeled LINE IN at the rear of
the Docking Base. Plug the other end of the supplied telephone cord into your
household wall jack.
5. Pick up your telephone receiver and verify that a dial tone is present. If you do not
hear a dial tone, check your telephone and Docking Base connections. If a dial
tone is still not present, consult the Indicator Lights and Troubleshooting section on
page 20 to identify the problem and resolution.
Docking
Base
Wall
Outlet
Telephone
Jack
The initial setup of your MedSmart is important in providing a safe
and reliable service. Place the Docking Base in a convenient
location in your home on a sturdy surface near a modular phone jack
and an electrical wall outlet.
Your MedSmart Unit is furnished with a set of 4 Alkaline AA batteries.
When the internal battery is low, the low battery symbol will show
on the display. Please immediately change batteries when this indicator
appears.
Setting Up
Docking Base Installation
Battery Compartment
Installation Note
UNIT POWER REQUIREMENTS AND RATINGS:
Power requirements: 120 VAC @ 1A
Power supply: 7.5 VDC regulated, 800 mA
