8
STOP: Change this setting only if the dispenser is being filled off-site and being
delivered to the caregiver at a later date. This setting is rarely adjusted.
If this function is not needed, tap button 1 until you reach RECORD.
If this function is needed, use the steps below.
1.
When in menu B, tap button 1 until ‘STOP’ is displayed.
2.
Set the Year (YY), Month (MM), Date (DD) and Hour (HH) to when you
want the dispenser to stop operating. Tap button 2 (decrease) or 3
(increase) the settings.
RECORD: Will show the time at which the previous 28 doses were dispensed
1.
When in menu B, tap button 1 until ‘RECORD’ is displayed.
2.
Tap button 2 (decrease) or 3 (increase) the previous dispensing times:
a.
‘1’ i
s the latest dispense time which occurred.
b.
‘2’ is the second latest dispense time which occurred.
c.
‘3’ is the third latest dispense time which occurred etc.
SAVE and EXIT Menu B:
1.
Press and hold button 1 for a few seconds to save and exit Menu B.
2.
The display will cycle between the current time and the current date.
SETUP - STEP 2
Filling the Tray
1.
With the lid still open, remove the tray that is inside the dispenser. This
makes filling the tray easier. Important: Never force the tray to rotate.
2.
e-pill MedTime Station Plus comes with three different dosing
templates. The template identifies the number of alarms per day and,
very importantly, the time of day that you are filling the tray. The blank
disc is used for 5 - 24 alarms per day. This disk has been intentionally
left blank so it can be customized. Place the correct template based on
your needs on the tray.
3.
Fill compartments counterclockwise with pills using the dosing
template as a guide. Important: Do not overfill any compartment. If one
of the doses does not fit into a single compartment, an additional alarm
can be set for shortly after the original alarm. The dose can then be split
into 2 compartments. Splitting larger tablets into smaller pieces using a
pill splitter can also help.
