EN
Model Assembly
Continued
A
B
B
B
3 x 20mm
Tapered hex head machine
A
3 x 16mm
Tapered hex head machine
B
Wing Installation
1. Rotate the wing struts into position in preparation for mounting the wing.
2. Slide the wings onto the wing tube.
3. Connect the servo and light connections together from the wing to the
fuselage. Ensure the cables from the wing are plugged into the correct
extension in the fuselage.
4. Secure the wing halves into position using the included 3 x 16mm hex head
screws
(B)
.
5. Secure the struts into position with one 3 x 16mm hex head screw
(B).
Disassemble in reverse order.
Propeller Installation
1. Install the spinner backplate, propeller, prop washer and spinner adapter.
2. Tighten the spinner adapter until the propeller is securely fastened.
3. Secure the spinner with a 3 x 20mm screw
(A)
.
Disassemble in reverse order.
6
Maule M7
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and sub-trims
to 0, then adjust the clevis to center the control surfaces.
• Turn the linkage clockwise or counterclockwise until the control surface is
centered.
• Attach the linkage to the servo arm or control horn after adjustment.
