EN
10
Maule M7
55 – 70mm +/- 3mm
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE:
If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual
for adjustment of gain values.
After fl ying, adjust the linkage positions for the desired control response if
necessary. See the table to the below:
SAFE
®
Select Switch Designation
SAFE
®
Select technology can be easily assigned to any open switch (two or
three position) on the transmitter. With this new feature, you now have the fl ex-
ibility to enable or disable the technology while in fl ight.
IMPORTANT:
Before assigning your desired switch, ensure that the travel for
that channel is set at 100% in both direction.
Assigning a switch
1. Bind the aircraft correctly to activate SAFE Select. This will allow the
system to be assigned to a switch.
2. Hold both transmitter sticks to the inside bottom corners and toggle the
desired switch fi ve times (one toggle = full up and down) to assign that
switch. The control surfaces of the aircraft will move, indicating the switch
has been selected.
Repeat the process to assign a different switch if desired.
TIP:
SAFE Select is assignable on any unused Channels 5–9
Mode 1 and 2 Transmitters
Factory Settings
Horns
Arms
Elevator
Rudder
Ailerons
Flaps
Center of Gravity (CG)
The CG location is measured from the leading edge of the wing. This
CG location has been determined with the recommended Li-Po battery
(EFLB22003S300) mounted all the way forward.
Begin with the battery all the way to the rear of the battery compartment when
running a battery larger than a 3S 2200mAh. Always confi rm the CG is located
correctly when changing the battery confi guration.
Back from the leading edge
of the wing at the fuselage.
two or three position switch
x 5
100%
100%
Tuning
Horns
Arms
More control throw
Less control throw
