13. Bend the wire at the mark. Drill a 5/64"
(2mm) hole in the servo arm and secure
the pushrod wire using a pushrod wire
keeper. Trim the rudder servo arm as shown
so it will not interfere with the operation of the
elevator servo.
Note
:.Trim.the.rudder.servo.arm.as.shown.in.
the.photo.
14. Prepare three CA hinges using T-pins. Use
the hinges to temporarily attach an elevator
half to the stabilizer, using
NO GLUE
.
Prepare another pushrod, clevis, clevis
retainer and control horn as was done for
the rudder. With the elevator at neutral,
mark the location for the control horn.
40
