15
E-flite Hurricane 25e PNP/BNF Assembly Manual
EN
1. Locate the carbon fiber wing tube. Slide the tube
in one wing panel. It should slide in easily, so do not
force it farther than it will slide. This will push the
wing tube into the foam in the wing, and possibly
prevent it from inserting fully into the opposite wing
panel.
2. Slide the remaining wing panel into position. The
panels will fit tightly together.
3. Separate the wing panels and remove the
fiberglass wing tube. Mix .50 ounce (15mL) of
30-minute epoxy. Apply epoxy to the fiberglass wing
tube and into both of the sockets in the wing panels.
4. Use an epoxy brush to apply a thin coat of epoxy
to the wing where the two halves fit together.
5. Slide the wing panels and tube together as shown
in steps 1 and 2. Use a #1 Phillips screwdriver and
two 3mm x 10mm countersunk self-tapping screws to
attach the forward wing dowel plate. This will hold
the front of the wing together while the epoxy cures.
Use a small piece of tape to secure the servo leads
so they don’t accidentally get glued to the wing.
6. Before the epoxy cures, use a small amount of
epoxy to secure the rear wing bolt plate, center wing
bolt plate, radiator scoop and the intake scoop to
the wing.