11
E-flite Funtana 300 Assembly Manual
Servo Installation
Required Parts
Airframe assembly
Micro control horn (4)
Long 3D servo arm (4)
Micro pusrod connector (4)
2mm x 4mm machine screw (4)
Micro control horn backplate (4)
Micro pushrod connector backplate (4)
10-inch (254mm) carbon pushrod
10
1
/
2
-inch (267mm) carbon pushrod
3
1
/
4
-inch (82mm) carbon pushrod (2)
Required Tools and Adhesives
Foam-safe CA
Pin drill
Drill bit: 1/16-inch (1.5mm) Hinge tape
Phillips screwdriver: #0
Low-temperature hot glue
Hot glue gun
1. Insert the micro control horn into slot in the
elevator from the top. Slide the micro control horn
backplate onto the control horn from the bottom side of
the elevator as shown.
2. Apply a few drops of foam-safe CA onto the
backplate to secure it to the horn.
