9
E-flite Funtana 300 Assembly Manual
4. Slide the stabilizer into the fuselage. Measure from
the tips of the wing to the tips of the stabilizer. The
measurements must match from right to left. If not, adjust
the position of the stabilizer until both measurements are
equal.
A
A
A=A
5. Step back and check that the wing and stabilizer are
parallel to each other. If not, lightly sand the stabilizer
saddle to correct for any alignment issues. Once fully
aligned, glue the horizontal stab in place using
foam-safe CA.
Parallel
6. Use foam-safe CA to glue the two 6-inch (152mm)
carbon rods between the fuselage and stabilizer. Make
sure not to change the alignment of the stabilizer when
installing the rods. The carbon rods will inset into the
bulkhead inside the fuselage.
