E-flite P-38/F-5E Lightning Assembly Manual
2. Turn on the transmitter and apply power to the
receiver. Check that the aileron servo is operating
properly. Center the aileron trim and control stick
and set any sub-trims to 0. Attach the servo arm to
the servo so it is as close to perpendicular as possible
when the servo is in the neutral position.
3. Use the included double-sided tape to install the servo
in the wing with the output shaft toward the trailing edge
and control horn.
4. Remove the backing from the pre-installed double-
sided tape on the wing panel cover. Position the servo
lead in the channel in the wing and attach the wing
panel cover after removing the backing from the factory-
installed double-sided tape. You can also use clear tape
around the edges of the bottom cover so it is more secure
during flight.
Note
: If you need to remove the servo cover after you
have taped it down, use caution as it could pull up your
paint with it.
