EN
1. Install the landing gear (
A
) with the wheel pants pointed to the rear as
shown.
2. Install the covers (
B
, marked L and R) on the strut and fuselage.
3. Install the fairings (
C
, marked L and R) on the fuselage using 4 screws (
D
).
When needed, disassemble in reverse order.
Tip:
Carefully support the aircraft while installing or removing screws.
Landing Gear Installation
A
Horizontal Tail Installation
1. Slide the horizontal tail tube (
A
) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Install 2 screws (
B
) in the holes in the bottom of the horizontal tail.
4. Attach the linkage (
C
) to the outermost hole in the elevator servo arm
using the link keeper and to the elevator control horn using the clevis.
5. Ensure the elevator servo arm is in the correct position, then adjust the
linkage to center the elevator.
When needed, disassemble in reverse order.
A
C
C
B
D
2 X 10mm (4)
B
3 X 17
9
