EN
MAINTENANCE
Sub-Fin Service
1. Turn over the model so the bottom faces up.
2. Remove the six screws and sub-fi n from the fuselage.
Assemble in reverse order.
2.5 X 10mm (6)
MAINTENANCE
Motor and Vectored-Thrust Service
Disassembly
1. Open the fuselage.
2. Remove the 12 screws (
A
) and upper motor housing (
B
) from the model.
2. Disconnect the motor wires from the ESC.
3. Disconnect the ball link from the arm of the vector-thrust servo or discon-
nect the vector-thrust unit’s arm from the lock to the fuselage, by remov-
ing the screw.
4. Remove the upper housing from the fuselage. The upper and lower bear-
ings may block easy removal of the housing and the vector-thrust unit
from the fuselage.
5. Remove the vector-thrust unit (
A
) from the fuselage.
6. Remove the four screws (
B
), washers (
C
) and X-mount
(D
) from the
vector-thrust unit.
7. Remove four screws (
E
) and washers (
F
) from the X-mount
and motor (
G
).
Assembly
Assemble in reverse order, aligning wire colors of the motor with the ESC for
correct operation. Remember to use threadlock.
NOTICE:
Make sure the propeller side with the numbers for diameter and
pitch (for example, 10 x 8) faces forward towards the front of the plane. A tool
is required to tighten the spinner nut on the collet.
Not all wiring shown.
A
D
4 X 9mm (4)
E
3 X 12mm (4)
B
G
(4)
C
(4)
F
2.5 X 10mm (12)
B
A
20