EN
®
Horizontal Tail Installation
1. Slide the horizontal tail tube (
A
) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Install 4 screws (
B
) in the front and rear holes in the bottom of the
horizontal tail.
4. Attach the ball link (
C
) to the elevator control horn’s outermost hole using
the included nut (
D
) and screw (
E
).
5. Ensure the elevator servo arm is in the correct position, then adjust the
linkage to center the elevator.
When needed, disassemble in reverse order.
Tip:
Use needle-nose pliers or ball link pliers (RV01005) to remove or
install a link on a control horn.
A
B
D
E
E
C
C
10
