E.F. Johnson 242-2008-332, Руководство пользователя

Страница: 30 / 51

PULL DOWN MENUS
4-2
September 1994
Part No. 001-2008-300
4.2.4 DOS SHELL
Temporarily suspends the program and returns to
DOS. Directories and other DOS commands can be
performed. To return to the program from DOS, type
EXIT and press Enter.
4.2.5 QUIT (ALT X)
Exits the program and returns to DOS. Be sure
all files are saved before exiting the program.
4.3 EDIT
Figure 4-4 EDIT MENU
This menu is used to create new files and set or
change the operating parameters. The filename for the
file being edited is shown in the lower left corner of
the screen.
4.3.1 SETUP PARAMETERS
Programs the Universal Station parameters and
options. Table 5-1 lists the parameters that are set by
this screen (see Figure 5-1) and gives a brief descrip-
tion of each.
NOTE: The parameters are shown in the lower left of
the pop-up screen for reference.
REPEATER NUMBER
Each repeater is programmed with a repeater
number from 1-20. Make sure that this number agrees
with the Home number programmed in the controller
assigned to this repeater.
NOTE: The Repeater Number is for reference only. It
is not necessary for repeater operation.
CHANNEL NUMBER
Each Universal Station is programmed with a
number of the channel that it is operating on (1-920).
If the operating frequency of a Universal Station is
changed, this channel number must also be changed
(see Appendix A).
RF POWER LEVEL
This is the default power level. Enter the power
level (25-75 Watts) that the Universal Station will use
for transmit power.
NOTE: Not the actual power out level. Other factors
must be considered for a true power out
.
POWER SOURCE
Indicates the primary type of power source the
Universal Station is powered from. AC or DC.
4.3.2 SELECT REPEATER
Select the repeater number to be programmed or
edited from the pop-up menu (see Figure 4-5). Move
the cursor with the arrow keys to highlight the
repeater number and press Enter.
Figure 4-5 REPEATER LIST
4.3.3 ALARM CONFIGURATION
This programs the input alarm (see Figure 4-7)
and output alarm (see Figure 4-8) configurations and
provides a cross reference screen.
Select Rptr
Alarm Config
File Edit Transfer Hardware Test Utilities
Auxiliary Parms
Setup Parameters F4
Delete Rptr
Repeater Type
Telephone Access Parms
Telephone Interface
TIC Calibration Data
Repeater List
default
Rptr 1
-------
-------
-------
Rptr 30