SMARTNET/SMARTZONE FEATURES
26
May 2002
Part No. 002-5100-100
•
If the system is busy when a response is made,
“BUSY” is displayed and the busy tone sounds.
Placing and Receiving Telephone Calls
The telephone call feature allows telephone calls
to be placed and received over the public telephone
system using your transceiver. The type of call
(secure/clear) is determined by the mode selected by
the Clear/Secure option key or menu parameter. Tele-
phone calls are programmed to operate in one of the
following modes:
•
Disabled
•
Answer-only capability
•
List only - Telephone numbers can be selected
from a preprogrammed list only (direct entry using
the keypad is not allowed)
•
Unlimited - Telephone numbers can be selected
from a list and also dialed directly entered using
the keypad.
Both limited and DTMF keypad models can place
telephone calls by recalling the telephone number
from a preprogrammed list as just described. However,
only DTMF keypad models can directly dial telephone
numbers using the keypad.
Placing a Telephone Call
Recalling From List
1. Momentarily press the Phone option key or select
that menu parameter. The alias of the last called tele-
phone number is displayed. The interconnect call
mode is indicated by
in the display.
2. If required, press the Up/Down switch to display the
desired number. The alias of each number is
displayed.
3. Press and release the PTT switch and “DIALING” is
displayed. Events that may occur are as follows:
(Proceed to the bulleted list which follows Item 3 in
the next section for events that may occur next.)
Direct Entry Using DTMF Keypad
1. Press and hold the Phone option key until a tone
sounds (approximately 1 second). The alias of the
last called telephone number is displayed if it is in
the phone number list. Otherwise, the last eight
digits of the last called telephone number are
displayed. The interconnect call mode is indicated
by
in the display.
2. Enter the telephone number using the 0-9,
*
, and #
keys. To enter a pause (indicated by “P”), press
*
and then #. To erase the last digit, press the F1 key.
The number scrolls to the left in the display so that
the eight right-most digits are always displayed.
Numbers up to sixteen digits (including pauses) can
be entered. Press the Phone option key to cancel the
call.
3. Press and release the PTT switch and “DIALING” is
displayed. Events that may occur are as follows:
•
If the access is successful, a dial tone sounds and
the dialed number is displayed and sent. Either
ringing or a busy signal is then heard as with a
standard telephone call. When the called party
answers, press the PTT switch to talk and release it
to listen (since the transceiver is half-duplex, it is
not possible to talk and listen at the same time).
Each time the PTT switch is released, a go-ahead
tone is sent to the landside party to indicate when
they can respond. To dial a number after the
connection is made, press the PTT switch and dial
the number using the microphone keypad.
•
If the selected telephone number is not valid,
“INVALID” is displayed and an alert tone sounds.
Select a valid number.
•
If the system is busy, “BUSY” is displayed and the
busy tone sounds. The call will automatically
proceed when the system becomes available.
•
If you are out-of-range or the radio cannot be
accessed for some reason, “NO PHONE” is
displayed and an alert tone sounds.
•
If the interconnect call you are making or the
selected secure mode is not authorized, “REJECT”
is displayed and an alert tone sounds.
