e-conolight E-WKL Series, Руководство по установке

Страница: 2 / 9

Document: Date
Created By: DCR#
LPN00650X0002A0_A
3-21-2019
TMT 010375
INSTALLATION INSTRUCTIONS
E-WKL Series
10,000L LED Portable Worklight
www.e-conolight.com | 888.243.9445 | FAX: 262.504.5409
FIGURE 2
Support Legs
Twist
Collars
Tripod
Center
Tube
Tripod Screw
End of Third
Support Leg
Lever
Tripod
Center Handle
Handle Screw
Power Cord
Stand
Screw
Lamp Head
Stand
Center Handle
Center Handle
Power Cord
Hook
ASSEMBLY
Attaching The Lamp Heads To The Stand - See Figure 1
1. Lay the lamp heads face down and position the stand against the
U-shaped bracket on the lamp head.
2. Attach the lamp heads to the stand by inserting the lamp head
screws into the bottom of the lamp heads and into stand.
Prepare The Tripod - See Figure 2
1. Loosen the tripod screw and move the support legs away from the
center tube of the tripod.
2. Push down on the leg connector until the support legs are fully
extended and firmly tighten the tripod screw.
3. Adjust the height of the tripod by loosening the black twist collars
on the center of the tube and raising the pole section.
4. Extend the end of the third leg as necessary for added balance in
various situations.
5. Firmly tighten the twist collars on the vertical pole and the end of
the support leg once you have adjusted the tripod to the desired
height and the support leg to the desired length.
Attaching The Lamps To The Tripod -
See Figure 3
1. Secure the center handle to the stand by inserting the handle
screws through the handle bracket and into the stand. Tighten the
handle screws.
2. Position the center of the stand over the center of the tripod
and insert the post on the bottom of the stand into the top of the
tripod.
3. Push the lever on the tripod to lock the stand in place.
4. To unlock the stand from the tripod, pull the lever and lift the
stand using the center handle.
Securing The Power Cord- See Figure 4
1. Attach the Y-shaped portion of the power cord to the center
handle using the screw that is preassembled to the cord.
2. Hook the bottom of the cord around the hook located on the
bottom of the tripod.
Lamp Head
Lamp Head
Lamp Head Screw
Stand
Lamp Head
Screw
FIGURE 3
FIGURE 4
FIGURE 1
Leg Connector