Dynon Avionics FlightDEK-D180, Руководство по установке

Страница: 152 / 154

Appendix
Appendix G: Replacing the FlightDEK-D180 battery pack
1. Remove the two screws (either #1 Phillips or 7
was manufactured) from the small, rectangular b
D180. Remove the battery door. Do not remove a
unit.
2. If you previously had a battery, disconnect it from t
the battery connector and gently pulling out old ba
battery wire to remove the battery.
3. Insert the new battery with the bumpy side up.
4. Connect the battery connector to the battery. The connector is keyed; make sure it is
positioned correctly.
5. Position the connecto
/64” hex, depending on when your unit
attery door on the side of the FlightDEK-
ny other screws from the case of the
he FlightDEK-D180 by unplugging
ttery. It is safe to
gently
pull on the
r so it is centered on the end of the pack. Verify that the battery
the door screws.
en to 12 in-lbs.
ircraf es t be aware of i and how
lan e ing a
on ed
......................................................... g)
........... ............... ................ )
.................................................................
............................................................................3.6 oz (0.102 kg)
3.2 oz (0.08 kg)
g)
.6 oz (0.16 kg)
............................4 oz (0.11 kg)
il temperature sender................................................................................................2 oz (0.06 kg)
Flush mount bracket....................................................................................................2 oz (0.06 kg)
EMS 37-pin wiring harness ......................................................................................13 oz (0.37 kg)
EMS 25-pin thermocouple wiring harness ...............................................................11 oz (0.31 kg)
EGT probe.................................................................................1.3 oz (0.04 kg) (times # of probes)
CHT probe ................................................................................1.3 oz (0.04 kg) (times # of probes)
pack will not interfere with insertion of either of
6. Reinsert screws and tight
Appendix H: Weights
Adding any new instrument to an a
that affects the overall weight and ba
FlightDEK-D180 and associated Dyn
FlightDEK-D180............................. t requir he installer to ts weight
ce of th
-suppli
plane. The follow re the weights of the
............2 lb 6 oz (1.08 k
sensors.
FlightDEK-D180 + battery ..........
EFIS 25-pin wiring harness ........
EDC-D10A ................................
EFIS OAT ................................................................................................................ ......... ....... ............2 lb 12 oz (1.25 kg
..........11.2 oz (0.32 kg)
Heated AOA/Pitot Probe & Heater Controller ......................................................11.2 oz (0.32 k
Unheated AOA/Pitot Probe......................................................................................5
Manifold pressure Sender ...........................................................................................3 oz (0.09 kg)
Oil pressure sender......................................................................................................4 oz (0.11 kg)
Fuel pressure sender........................................................................
O
9-36 FlightDEK-D180 Installation Guide