Dynon Avionics FlightDEK-D180, Руководство по установке

Страница: 122 / 154

Appendix
9-6 FlightDEK-D180 Installation Guide
Problem Solution
Internal battery life is too short Verify internal battery is charged to above 16 volts using
FlightDEK-D180 voltmeter.
Re-run capacity test.
Replace battery if insufficient capacity.
Clock setting is lost If present, verify internal battery is charged.
If no internal battery, verify Keep Alive power is supplied to
unit at all times.
Cannot make connection with PC Verify wiring is correct.
Verify no other programs using the COM port are running
on the PC.
Verify latest version of The Dynon Product Support Program
is being used.
Unit will not boot off battery
power This can be normal behavior for the FlightDEK-D180. When
booted off master power, the FlightDEK-D180 will have no
problem continuing to run off battery power. However, at
startup, it draws more current than the battery can provide.
INSTRUCTIONS FOR RETURN
If none of the above sections have helped resolve an ongoing issue with your FlightDEK-D180,
please call Dynon Avionics at 425-402-0433 to discuss the issue with Technical Support. If, after
troubleshooting with a Dynon representative, the issue cannot be resolved, we will provide you
with an RMA number to use when shipping the FlightDEK-D180 to us. If your unit is still under
warranty, the repairs will be performed and the FlightDEK-D180 will be returned promptly. If
your warranty has expired, the Dynon representative will make arrangements with you and make
you fully aware of the costs before proceeding with the repair.
We recommend that you also send your EDC-D10A remote compass along with your
FlightDEK-D180. This ensures that if we upgrade the firmware in your FlightDEK-D180, the
EDC-D10A will have corresponding firmware.
While Dynon Avionics makes every effort to save and restore your unit’s settings and
calibrations, we cannot guarantee that this will happen. Please note that after you receive your
unit back from Dynon Avionics with a factory calibration, the heading display on the
FlightDEK-D180 may be inaccurate once re-installed in your aircraft, due to installation-specific
magnetic effects. If this is the case, you will have to perform the magnetic calibration again.
When you receive your FlightDEK-D180, it may have newer firmware installed on it than it did
when you sent it in. Check
downloads.dynonavionics.com for information on what’s new.