2009 Yamaha FZ1 PCV -
4
22-015 www.powercommander.com
FIG.D
FIG.E
8
Attach the ground wire from the PCV to the negative side of the battery
(Fig. D).
9
Locate the stock O2 sensor in the exhaust. Follow the O2 sensor har-
ness and unplug it from the main wiring harness (Fig. E)..
10 Plug the Dynojet O2 optimizer into the main wiring harness.
The stock O2 sensor will not be connected to anything anymore
FIG.F
11 Install the PCV in the rear section of the trunk (Fig. F).
12 Make sure all the wires are routed properly.
13 Reinstall the main seat and the passenger seat.
Speed input
- Pink wire on white 3 pin connector under fuel tank
Temperature input
- Green/White wire - same plug as PC
12v source for Auto tune
- BLUE wire of tail light connector
