Dynapac ICA362, Инструкция по эксплуатации

Страница: 61 / 121

Operation
ICA362-4EN3.pdf 2012-06-12
Manual vibration - Switching on
38
42
Fig. Control panel
38. Switch, vibration On/Off
42. Parking brake knob
Never activate vibration when the roller is
stationary. This can damage both the surface and
the machine. Never activate vibration when the roller is
stationary. This can damage both the surface and
the machine.
Engage and disengage vibration using the switch (38)
on the front of the forward/reverse lever.
Always switch off vibration before the roller comes to a
standstill.
If the parking brake knob (42) is activated the engine
will not stop.
Braking
Emergency braking
37
39
Fig. Control panel
37. Emergency stop
39. Forward/Reverse lever
Braking is normally activated using the
forward/reverse lever. The hydrostatic transmission
retards and slows the roller when the lever is moved
towards the neutral position.
A disc brake in the drum motor and rear axle acts as
an emergency brake when in motion and as a parking
brake when stationary.
For emergency braking, press the emergency stop
(37), hold the steering wheel firmly and be
prepared for a sudden stop. The brakes are
applied and the engine stops. For emergency braking, press the emergency stop
(37), hold the steering wheel firmly and be
prepared for a sudden stop. The brakes are
applied and the engine stops.
After emergency braking, return the forward/reverse
lever to the neutral position and pull up the emergency
stop (37). The roller is fitted with an Interlock and
therefore the operator must sit in the seat to start the
engine.
51