Dynapac CP2700, Инструкция по эксплуатации

Страница: 35 / 113

Regeneration System
2018-02-19 4812325557EN 31
Regeneration system
(Emission Control)
After Treatment Screen
In this screen you will find urea tank level, warning lamps and
engine oil temperature.
Make sure that the Urea tank is full during operation.
It´s recommended to fill or drain the tank with the system off.
If the Urea tank is completely empty you may have error
codes related to the after treatment system in the
display due to invalid measurements. To clear the error
code the tank must be filled and perform a key cycle,
start the engine and run it in high idle for 5 minutes.
Diesel Exhaust Fluid (DEF) Lamps
DEF Lamp
Illuminates when DEF level is low, and flashes when the DEF
falls below a very low level. Operator should refill the DEF tank
with DEF.
DEF Lamp With Check Engine Lamp
Illuminates when the DEF level is critically low. If the tank is not
refilled immediately, power will be reduced. Operator should
refill the DEF tank with DEF. Normal engine power will be
restored after the DEF tank is refilled.
Flashing DEF Lamp With Check Engine Lamp
Illuminates when the DEF level is near zero. If the tank is not
refilled immediately, power will be further reduced. Operator
should refill the DEF tank with DEF. Normal engine power will
be restored after the DEF tank is refilled.
Flashing DEF Lamp With Stop Engine Lamp
Illuminates when the DEF gauge has read zero for 30 minutes.
Power will be limited to idle. Operator should stop the equipment
when it is safe to do so, and refill the DEF tank. Normal engine
power will be restored after the DEF tank is refilled.
Fig.
– After Treatment screen