Dynapac CP142, Руководство по обслуживанию

Страница: 26 / 29

24
CP142 M142EN1
LONG-TERM PARKING
For long-term parking (longer than one month),
the following instructions should be followed.
These instructions apply for parking lasting up
to 6 months.
Before re-commissioning the roller, the points
marked with an asterisk
M
must be performed.
Fig. 36 Protecting the roller from the
elements
* See the manufacturer’s instructions in the engine
instruction manual, which is supplied together with
the roller.
* Remove the battery from the roller, clean it’s
exterior, check its electrolyte level and recharge it
once a month.
* Cover the air cleaner or its opening with plastic or
tape, and cover also the exhaust pipe’s opening.
This is done so as to prevent moisture from
penetrating into the engine.
Fill the fuel tank to the brim to prevent condensation.
Drain off any condensation water and fill the hydrau-
lic reservoir to the uppermost level mark.
Grease the steering-joint bearings and both bearings
of the steering cylinder. Grease the piston rod of the
steering cylinder with inhibitor grease. Also grease
hinges of the engine compartment and cab doors,
and both ends (bright parts) of the forward/reverse
control.
Jack up the frame, so that the tires do not take any
load.
* Place the instrument cover on the steering column.
Cover the entire machine with a tarpaulin, which
should hand some way off the ground. If possible,
store the roller indoors, preferably in a building with a
uniform temperature.
* Drain the water tank and hoses completely. The fil-
ter housing and the water pump must be emptied.
Remove all the sprinkler nozzles.
Diesel engine
Battery
Air cleaner, exhaust pipe
Covers, tarpaulin
Fuel tank
Tires
Steering cylinder, hinges etc.
Hydraulic reservoir
Sprinkler system