Dynapac CC 501, Операция

Страница: 22 / 28

20 CC 501/501C O501EN3
STOPPING
Normal and EMERGENCY STOP
BRAKING
Braking is normally done with the forward/reverse
lever. The hydrostatic transmission brakes the roller
when the lever is moved toward neutral. In addition, a
disc brake in each gearbox is applied when the reserve
brake knob (11) is pressed in. Lamp (10) lights.
EMERGENCY BRAKING
In an emergency, press the reserve brake
knob (11). Hold the steering wheel firmly as
the roller brakes.
After emergency braking: Set the forward/reverse lever
in neutral. Pull out the reserve brake knob (11).
The disc brake is automatically applied to stop
the roller if the engine stops or if hydraulic
pressure is insufficient for any other reason.
Stopping the engine
Press (23) to switch vibration off if the vibration selec-
tor (27) is in the MAN mode. Set (27) and the amplitude
selectors (28, 29) to the O mode.
Move the forward/reverse lever to neutral to stop the
roller.
Set the engine speed to about 1000 rpm (32) and allow
it to run for a few minutes to even out the temperature.
Press the parking brake knob (11).
Turn the switch (9) to the O position to stop the engine.
Place the protective cover over the control table. Lock
as required.
Switch the battery disconnector OFF and remove the
handle from the switch.
When you start up and drive a cold machine,
the hydraulic fluid is cold, and the braking
distance will be longer than normal until the
machine reaches normal working tempera-
ture.
23
24
32 29 28 27
11
9
11
10
Fig. 21 Instrument panel
10. Indicator lamp, brakes
11. Reserve brake knob
Fig. 22 Instrument panel
9. Switch
11. Parking brake knob
23. Vibration ON/OFF
24. Forward/Reverse lever
27. Vibration selector
28. Amplitude selector, front
(CC 501C only)
29. Amplitude selector, rear
32. Rev control