Dynapac CA250 i, Инструкция по эксплуатации

Страница: 89 / 93

Maintenance - 2000h
ICA250i-IN2EN1.pdf 2012-12-19
Maintenance - 2000h
Park the roller on a level surface.
When checking and making adjustments, the
engine should be switched off and the
emergency/parking brake should be applied, if
not otherwise specified. Park the roller on a level surface.
When checking and making adjustments, the
engine should be switched off and the
emergency/parking brake should be applied, if
not otherwise specified.
Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning. Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Hydraulic reservoir - Changing the fluid
Fig. Hydraulic reservoir, bottom
1. Stop cock (3/4")
2. Plug
1
2
Observe care when draining the hydraulic fluid.
Wear protective gloves and goggles. Observe care when draining the hydraulic fluid.
Wear protective gloves and goggles.
Place a receptacle that holds at least 60 liters (15.9
gal)) beside the roller.
Unscrew the drain plug (2).
Open the stock cock and allow the oil to run through a
hose to the drainage receptacle.
Refit the plug.
Deliver the drained fluid to environmentally
correct handling. Deliver the drained fluid to environmentally
correct handling.
Fill with fresh hydraulic fluid. Refer to the lubricants
specification for grade information.
Change the hydraulic fluid filter as described under the
heading 'Every 1000 hours of operation'.
Start the engine and operate the hydraulic functions.
Check the level in the reservoir and top off as required.
81