Dynapac CA250 i, Инструкция по эксплуатации

Страница: 44 / 93

Operation
ICA250i-IN2EN1.pdf 2012-12-19
Braking
Normal braking
1
4
33
3
6
31
Fig. Control panel
1. Key
3. Emergency shut down
4. Vibration On/Off.
6. Forward/Back regulator
31. Parking brake starting switch
33. Engine speed control
Press the switch (4) to switch off the vibration.
Move the forward/reverse lever (6) to the neutral
position to stop the roller.
Turn the engine speed control (33) forward to idling
position.
Set the parkering brake switch (31) in the On position.
Always use the parking brake (31) when the
machine is stationary on a sloping surface. Always use the parking brake (31) when the
machine is stationary on a sloping surface.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature. When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
Emergency braking
3
Fig. Instrument panel
3. Emergency stop
Braking is normally activated using the
forward/reverse lever. The hydrostatic transmission
brakes the roller when the lever is moved towards the
neutral position.
There is also a brake in the drum motor and rear axle
that acts as an emergency brake during operation.
For emergency braking, press the emergency stop
(3), hold the steering wheel firmly and be prepared
for a sudden stop. The brakes are applied and the
engine stops. For emergency braking, press the emergency stop
(3), hold the steering wheel firmly and be prepared
for a sudden stop. The brakes are applied and the
engine stops.
After emergency braking, return the forward/reverse
lever to neutral position and pull out the emergency
stop (3). When the roller is fitted with an Interlock it is
necessary to sit down in the driver seat to restart the
engine.
36