19
CA 251 M251-1EN1
Place the roller on a level surface. Switch
off the engine and apply the parking brake/
Reserve brake.
The oil drain plug (1) is most easily accessible from
underneath the engine. Drain off the oil while the engine
is warm. Place a receptacle that holds at least 15 litre
(15.9 qts) under the drain plug.
Danger of being burned when draining hot
oil. Protect your hands
Replace the engine oil filter (2) at the same time. See
also engine instruction manual.
EVERY 250 HOURS OF OPERATION (MONTHLY)
1
3
2
Ensure that the roller is level.
Wipe clean round the level plug (2) and unscrew it a
few turns. Ensure that the oil level reaches up to the
lower edge of the plug hole.
Top up as required through the filler plug (1) to the
lower edge of the level plug (2). Wipe clean round the
filler plug before unscrewing it. Use transmission oil,
see the lubricant specification.
There is a level plug on each side of the trans-
fer gearbox. It is only necessary to make a
level check on one side.
Fig. 33 Transfer gearbox, left side
1. Filler plug
2. Level plug
3. Drain plug
Inspect tightening of bolted
joints
28
25
20
Rear axle suspension (25) 434 Nm (320 lbf.ft).
Steering pump against propulsion pump (20) 38 Nm
(28 lbf.ft).
Engine suspension (28). Check that all bolts are tight-
ened, 90 Nm (66.4 lbf.ft).
Wheel nuts (23). Check that all bolts are tightened, 550
Nm (405.7 lbf.ft).
(The above applies only to new or replaced compo-
nent).
23
Fig. 34 Drive unit
Transfer gearbox
– Checking the oil level
Fig. 32 Engine, left side
1. Drain plug
2. Engine oil filter
Diesel engine –
Oil and filter change
1
2
Содержание CA 251
Страница 2: ......
