Dynapac CA 251, Руководство по обслуживанию

Страница: 13 / 32

11 CA 251 M251-1EN1
EVERY 10 HOURS OF OPERATION (DAILY)
1
Place the roller on level ground and check that the oil
level is between the max. and min. marks in the sight
glass (1).
Top up with hydraulic fluid according to the lubricant
specification if the level is too low.
Fig. 8 Hydraulic reservoir
1. Sight glass
Hydraulic reservoir
– Checking the fluid level
Diesel engine
– Checking the oil level
Fig. 10 Engine compartment
1. Oil dipstick
Place the roller on a level base. The engine
is to be switched off and the parking brake
applied for all checking and adjustments
on the roller unless stated otherwise.
Beware of hot parts of the engine and hot
radiator when taking out the oil dipstick.
Danger of being burned.
The dipstick is on the right-hand side of the engine.
Pull the dipstick (1) up and check that the oil level is
between the upper and lower marks. See the engine
manual for further details.
1
Hydraulic reservoir – Filling
Fig. 9 Battery box
1. Suction hose
2. Protective plug
3. Pump arm
Remove the cover on the right side under the
operator’s seat.
Take out the suction hose (1).
Clean the hose and screw off the protective plug (2).
Insert the hose into a barrel of fresh hydraulic fluid.
Attach the pump arm (3), and pump until the reservoir is
full according to the marks on the sight glass. Hydraulic
fluid is pumped to the reservoir through a filter, so
always fill with fluid in this way.
3
1
2