23. FACTORY RESET PAGE
This function allows the camera to delete the all
programmed data and go back to default status.
If you select this menu, the camera is rebooting.
Move the joystick up or down to position the cursor on the
parameter:
It appears the warning message.
Joystick left or right on this menu: go back to reboot.
SYSTEM REBOOTING
If you want to make a rebooting your dome system, please
put the following command with the dedicate keyboard
controller.
press +
+
(Press the each button in order)
It allows the above command to make a rebooting your
dome system without delete programmed memories in
your dome system.
For the keyboard controller(Telemetry), please ask to the
supplier for your dome system.
PRESET PROGRAMMING
The Superior Speed Dome System allows user to
program preset up to 64-preset positions with the
keyboard controller.
The following steps are the settings:
Before setting, position to camera as you desire with
the joystick. Press
key and enter preset
number
, press
key on the keyboard.
It appears messages on the monitor.
How to program the presets:
SET:
+ Preset No
~
+
DELETE:
(for 3 seconds) + Preset No
~
+
+
DELETE ALL:
(for 3 seconds) +
+
8. PRESET PROGRAMMING
<< CAMERA SETUP p3 >>
17. Select Alarm
: Sensor
18. Motion on/off
: Off
19. Motion Detection Set :
20. PRIVACY ZONE SET :
21. ALARM CH ON/OFF PAGE
22. ALARM PRESET SET PAGE
23. FACTORY RESET WARNING!
- PREV MENU PAGE
NOTE : Warning! If you select the menu, all of the
programmed data is loosen.
NOTE: These buttons are not pressed at the same
time. It is pressed each button in order.
Flash Memory Initial!
100%
<View on the monitor>
CAM-001
Set PST01
CAM-001
PST01
CAM-001
Clr PST01