Dynamic DX-REMG91, Руководство по установке

Страница: 52 / 80

GBK63648
:
Issue 3
– February 2012
46
6 Programming G91
Warning:
Performance adjustments should only be made by professionals in
the health care field or by persons fully conversant with the
adjustment process and the user’s capabilities.
Incorrect settings, or programming in an unsafe location, could
cause injury to the operator or bystanders, or damage to the vehicle
or surrounding property.
After the vehicle has been configured, check to make sure the
vehicle performs to the specifications entered in the programming
procedure. If the vehicle does not perform to specifications,
reprogram it. Repeat this procedure until the vehicle performs to
specifications. If the intended operation cannot be achieved,
contact your service agent.
Ensure that deceleration parameters are always higher than
acceleration parameters for a safe response.
It is the health care professionals responsibility to ensure that the user is
capable both of cognitively understanding and physically operating
the programmed features and functions.
With inappropriate programming settings, certain features and options
may not be accessible or perform as expected.
6.1 Introduction
DX is a fully programmable system, which can be optimised for particular chair types
and to suit the driving environment and preferences of individual users.
The driving performance of the DX System is dependent on its programming with the
DX Remote and Power Module being the modules most responsible for defining the
driving performance of the DX System.
DX can be programmed at 3 points:
During manufacturer by Dynamic – Default Programs
Prior to shipping, each module is loaded with appropriate default
settings.
By the Wheelchair Manufacturer (OEM)
OEMs use the PC based “Wizard” programming tool to develop
programs optimised for particular wheelchair models. Each program
defines the technical attributes necessary to match the controller to the
chair (current limits etc), as well as a drive performance that suits the
typical user. The resulting programs may be copied into each DX System
as part of the chair production process.
The G91 range of controllers are programmable via Wizard version 5.03
and later.