Dynamic DX-REMG91, Руководство по установке

Страница: 42 / 80

GBK63648
:
Issue 3
– February 2012
36
4.5 ECU Scanning Modes
4.5.1 ECU1 Mode
When using the scanner function ECU1 Mode only provides a momentary output on
Channel 1 (ECU1-1) (Pin 1) Pressing the AUX button when only the ECU Mode LED is
illuminated will „activate‟ the Channel 1 output. Once the switch is released the G91S
will continue to scan through the available modes.
4.5.2 ECU2 Mode
To configure a DX-ECU as ECU2 the Molex jumper connector should be inserted..
Refer to DX-ECU installation manual (GBK64227) for further details.
ECU2 can be operated in either latched mode or linked mode. For more information
on Latched mode see the programming section.
Linked Mode:
To enter ECU2 press „AUX‟ when both ECU mode indicator and ECU2-1 (diamond
symbol) are lit.
The G91S will scan through the 4 ECU2 outputs. Pressing the AUX button when the
desired LED is lit will link the output on the selected channel. The output will be
„active‟ momentarily whilst the AUX button is pressed. The selected ECU2 output
symbol will continue to flash. Every press of „AUX‟ will cause an „active‟ output. The
G91S will remain flashing on the selected output until the AUX button is pressed for
greater than 3 times the
Scan Rate . The G91S will return to Home Level.
Latched Mode:
In Latched mode when the selected ECU2 output is selected the output will remain
„active‟ until the AUX button is pressed again. Set
ECU2 is Latched to enable, refer to
programming section.
To enter ECU2 latched press „AUX‟ when both ECU mode indicator and ECU2-1
(diamond symbol) are lit.
The G91S will scan through the 4 ECU2 outputs. Pressing the AUX button when the
desired LED is lit will latch the output on the selected channel. The selected ECU2
channel will remain „active‟ until the „AUX‟ button is pressed again. The output
channel symbol will remain lit whilst the output is „active‟.
The G91S will remain on the selected ECU2 output channel with the LED symbol
flashing. To return to the Home Level press and hold the „AUX‟ button for greater than
3 times the
Scan Rate .