Dynamic Displays, Inc. User Manual Doc: 0048070
1625 Westgate Road 17C3 A/D Series Rev 2
Eau Claire, WI 54073 Glee 17C3 Page #24 of 26
f)
LVDS Percentage (%) ------------------------- 1.00 %
g)
Panel Swing ------------------------------------- 250
5)
SPECIAL SET
a)
2 Hour OFF -------------------------------------- Off / On
b)
WDT ----------------------------------------------- Off
c)
White Pattern ---------------------------------- Off / White / Red / Green / Blue / Black
d)
GE/GOP Pattern
e)
BMAP Pattern
f)
Restore Factory Defaults
g)
Power --------------------------------------------- On /Last / Off
i)
Power plug remove and then plug in.
(1)
Select "On": that means "remove power plug, then plug in, monitor is ON".
(2)
Select "Off": that means "remove power plug, then plug in monitor is OFF". If you want monitor on,
then you must press power key on keypad.
(3)
Select "Last": that means "remove power plug, then plug in, monitor power ON or OFF will follow
the last status of "on" or "off" just before the power plug is removed".
h)
VGA2 Enable ------------------------------------ On / Off
i)
HDMI2 Enable ---------------------------------- On / Off
j)
Power Savings Enable ----------------------- On / Off
i)
Message “No Signal” displays when signal input is removed or not present. This message will show for 4
minutes. Thereafter a new widow will
appear warning “Monitor will shut
-
down in 60 sec”, press any key
or applied video to disable the turn off. After this period the monitor will shut down consuming less
than 1 watt.
k)
Burn-In Mode ---------------------------------- On / Off
i)
No signal applied to activate Burn-In Mode.
ii)
Set Burn-In
to “
ON
”.
iii)
Press Menu (several times) to leave Factory mode.
iv)
Burn-In is activated.
v)
When “Burn
-
In” is activated, no matter if “Power Saving”
is set at
ON or OFF, the “Power Savings”
function is disabled.
vi)
Apply video to exit burn-in mode.
l)
AUTO-Programming
i)
Refer to work instructions document #0046XXX “17C3 MCU Auto
-
Programming” for precise instructions
.
m)
SOG Function ----------------------------------- On / Off
i)
ON -------------------------------------------- Provide the option to extracted synchronization information from
SOG signal.
ii)
Off -------------------------------------------- Separate Sync or Composite Separate Sync need to be present.
n)
Auto-Progr Timing ---------------------------- Disable/Enable
i)
Use to restore A/D Board to original “Factory Programming Settings”. Refer to Procedure “Work
Instructions, 17C3 MCU, Restore A/D Board Programming to Original Settings”.
6)
VIF1
7)
QMAP ADJUST
8)
PEQ
9)
OverScan
