Page 5
3101C Gen II MANUAL
11/17
INSTALLATION INSTRUCTIONS
705 Emmett Street Bristol, CT 06010
1-877-DynaLock www.dynalock.com
3101C
DELAYED
EGRESS LOCK
(GENERATION II)
MOUNTING THE LOCK
Before installation begins remove the rear Electronics Cover,
End Cover and Sensor Cover Assembly (see page 14 for parts
locations). Carefully unplug the sensor harness from the circuit
board connector labeled J5 then detach the Sensor Cover
Assembly from the lock. In the upper inside corners of the lock
housing are located two #1/4-28 set screws. Using the 1/8” ball
head hex wrench loosen
(do not remove)
the two set screws
until the Fas-Trak Baseplate is free (Fig. “C”). Remove the Fas-
Trak.
Place the Fas-Trak against the header with the slot counter bores
visible and the tabs facing the door (Fig. “A”). Attach the Fas-Trak
to the header at both slotted hole locations, with two #10 x 1” tek
screws or 10-24x1/2” machine screws. Tighten the screws just
snug enough to allow for final adjustment.
Temporarily mount the lock to the Fas-Trak by offsetting the lock
1-1/8” from the jamb (Fig. “C”) and tipping the front of the lock
down engaging the rear flange of the Fas-Trak (Fig. “B”). Rotate
the lock up allowing one tab to pass through the corresponding
notch in the top of the lock housing. Slide the lock into position.
Close and latch the door. Check that the armature and lock
faces make full contact. If any adjustment is required gently tap
the housing with a soft mallet until full contact is achieved. Open
the door, remove the lock from the Fas-Trak and tighten both
slot screws. Drive three more screws into the header using the
Fas-Trak as a physical template. Screw heads must not project
above the Fas-Trak.
Any roughed-in wiring may be brought in at this time through the slotted wiring holes. Re-install the lock on the
Fas-Trak. Firmly tighten both housing set screws with the 1/8” ball head hex wrench. Re-install the End Cover and
Sensor Cover Assembly. Carefully plug the Sensor harness back into the J5 connector on the circuit board (see
page 13 for connector information).
If the lock wiring and set-up are not being done at this time replace the
Electronics Cover and see that these instructions are left for the electrical installer.
1.
2.
3.
4.
FAS-TRAK
TABS
SET
SCREW
LOCK
VERTICAL JAMB
FIG. “C”
1-1/8” OFFSET
TABS FACING DOOR
VISIBLE SLOT
COUNTER BORES
LOCK
ENGAGE
REAR
FLANGE
FAS-TRAK
FIG. “B”
FIG. “A”
SET
SCREW
