21
HOW TO REPLACE REAR WHEEL AND GEAR BOX
1. Remove the axle cap by sliding a flat head screwdriver along the edge of the cap
and carefully prying the cap open.
2. Use needle nose pliers to remove the split pin in the hole of the rear axle end.
3. Remove the M10 locknut with a 17 mm socket wrench.
4. Remove the Ø12 washer.
5. Remove the rear wheel and replace with a new wheel.
–
If you do not need to replace the gear box, please proceed to step 9.
6. Unscrew the 4 screws on the motor cover under the toy body, and remove the
motor cover.
7. Unplug the motor output connector that is connected to the gearbox, and replace
with a new gearbox, and tightly plug the motor output connector into the new
gearbox motor connector.
8. Remount the motor cover with four 4x12 round head screws.
9. Remount the new wheels (See Rear Wheel Assembly steps on Page 10).
WARNING:
Make sure the wheels are securely attached before letting anyone use
the ride-on toy.
Motor Output
Connector
Motor
Connector
Gear Box
Rear Wheel
M10
Locknut
Axle Cap
Motor Cover
Split Pin
Rear Axle
4x12 Round Head Screw
Ø12
Washer
