PROUDLY DESIGNED, ENGINEERED, AND BUILT IN AMERICA SINCE 1969
Dynabrade, Inc.
8989 Sheridan Drive
|
Clarence, New York 14031
|
dynabrade.com
CARRIAGE HANDLE
ASSEMBLY
19. Before replacing tank cover, refer to
Dry Pick
Up
or
Wet Pick Up Operation
in user manual
to ensure you have the proper filters installed for your
(Not standard)
You will find one carriage handle
FIGURE 13
and a
handle pack containing two side tank handles
FIGURE 14
, four handle supports
FIGURE 15
and
eight screws. Assemble as follows:
GENERAL SET UP
FIGURE 20
FIGURE 13
FIGURE 14
FIGURE 15
FIGURE 21
FIGURE 16
FIGURE 22
16. With rear of unit facing you, take
hose holder and position it with tabs
facing rear of unit.
FIGURE 20 .
17. Place “J” shaped tabs into the
slots on cord wraps.
FIGURE 21.
Press down until tabs snap into
place.
11. Take two handle supports and
two 1” screws. Place screws through
the hole provided in center of each
support.
FIGURE 16
.
12. Position the tank, in the upright
position, with the inlet facing you.
Put the support assemblies inside
the tank, then place the screws
through the holes provided on left
side of the tank. Make sure the
plastic portion is located inside the
tank. Turn the supports until the
back of the supports fit flush against the inside curve
of the tank.
FIGURE 17.
13. Remove any webbing that
attaches the tank handles to each
other. Take the side tank handle
with the letter
L
and position it on
the outside of the tank where the
support assemblies are installed.
The U-shaped cutout on the bottom
end of the handle must face the rear of the tank. Secure
the handle to the tank with the screws in the support
assemblies.
FIGURE 18.
15. Position metal carriage handle
outside of tank and under the tank
handles. Be sure to spread ends of
carriage handle when assembling
to prevent damage to tank. Line up
holes in ends of carriage handle with
holes in bottom of tank handles.
Make sure carriage handle is in the U-shaped cut on the
tank handles (located towards rear of unit). Secure with
1½” screws provided.
FIGURE 19.
14. Repeat steps 11 to 13 using right side of tank and
the remaining handle marked with the letter
R.
18. Press down on center of hose
holder until tab latches on bottom of
tank cover.
FIGURE 22.
HOSE HOLDER
INSTALLATION
(Not standard)
FIGURE 17
FIGURE 18
FIGURE 19
PAGE 7
FIGURE 9
FIGURE 10
11. Secure with four screws
provided.
FIGURE 9
.
12. If flat washers are included in hardware package,
place one flat washer over stem of each caster.
NOTE:
Flat washers are not required with all units.
13. Insert casters into front of dolly
by placing stem of casters into
holes provided. Apply pressure and
twisting motion until casters snap
into place.
FIGURE 10
.
14. Return tank to upright position.
Содержание Mini-Raptor Vac 61100
Страница 14: ......
