Dyna-Glo EG10000DH, Руководство пользователя и инструкции по эксплуатации

Страница: 12 / 46

4. DOWN Control Button:
7. Fahrenheit/Celsius Button:
REMOTE:
This button displays F (Fahrenheit) or C (Celsius) depending on how the
temperature mode is set. When the garage heater is turned on, the
Fahrenheit (F) temperature will be displayed.
GARAGE HEATER :
To switch from Fahrenheit to Celsius, or vise-versa, when the garage
heater is ON, hold HEATER CONTROL button for 5 seconds. Unless
power to the unit has been interrupted, the garage heater will remember
the last temperature mode setting will start at that setting,
horizontally if it has been installed with 2 lag bolts.
2. To tilt the unit vertically, loosen the bracket screws (see
Fi
gure 5
on page 6
).
ADJUSTING AIR FLOW DIRECTION
1. To turn the unit when it has been installed with a single lag bolt (as shown in
figure 4a), simply turn the entire heater as needed. The unit cannot be turned
OPERATING INSTRUCTIONS
12
6. Timer Button:
This button controls the Timer ON/OFF and 8 settings from 1hour to 8
hours. When the Timer is first turned on, it will come on at the shortest time
setting (1hour). Each time the Timer button is pressed, the time increases
by 1 hour, up to the longest setting (8 hours). Once the set time expires, all
garage heaters functions will be automatically turn off.
5. UP Control Button:
This button is increasing temperature or timer setting. It adjusts the
temperature range between 20°C--35°C (68°F--95°F) in 2°F (/1°C)
increments.
This button is used to decrease temperature or timer settiing. It adjusts the
temperature range between 20°C--35°C(68°F--95°F) in 2°F (/1°C) increments.