Dyna-Glo EG10000DH, Руководство пользователя и инструкции по эксплуатации

Страница: 9 / 46

Warning: This appliance must be grounded!
Warning: The appliance must connect to a current protection circuit or
device at 50Amp or less before being connected to power supply!
WARNING
WARNING
CAUTION
CONNECTING THE POWER
3. Connect the wire to the power block located in the base of the heater - See Figure 7.
4. Turn on the power at the main service.
TO PROTECT THE HEATING ELEMENT
When start
ing
the heater, turn
ing
the temperature control clockwise slowly to
terminal, the unit starts the fan first then star
ts
the heating element.
When
shutting off t
he heater, turning the temperature control
counter
clockwise
t
o off, the heating element first
will turn off
then the fan
will run
a short cooling cycle and then turn off.
NOTE: All wiring must be carried out by a Certified Electrician and must be in
accordance to national and local electrical codes in the United States. For certain
applications, conduit may be required, See Figure
7
. Check local electrical codes.
If you run the wiring in conduit and wish to be able to turn the heater be sure to
purchase enough flexible conduit to allow the heater to be turned.
1. Remove the screw from the front of the unit to connect the power to the heater.
2. Attach the cable connectors to the unit (See Figure
7
) and slide the 10-gauge
wire through the cable connector.
High temperatures – risk of fire. Keep flammable materials, such as
furniture, pillows, bedding, papers, clothes and curtains at least 3 ft. (0.9
m) from the front and top of the heater and keep them away from the
sides and rear. To reduce the risk of fire, do not use it in areas where
gasoline, paint or flammable liquids are used or stored.
3. The external temperature control (external thermostat) should be in
accordance with the requirement of UL or
CSA
standard.
4. The lead wire of external temperature control (external thermostat) can not
less than 14AWG.
9