Dyna-Glo DGSS700BPW, Руководство пользователя

Страница: 31 / 109

31
TROUBLESHOOTING
If you have any questions regarding the product, please call customer service at 1-877-447-4768,
8:00 a.m. – 4:30 p.m., CST, Monday – Friday.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Unit will not turn
on / No Power.
• Not Connected To Power
Source, GFCI Outlet Has
Tripped.
• Fuse Blown On The Control
Board.
• Ensure the unit is plugged into a working
power source. Reset outlet breaker.
Ensure GFCI is capable of handling a 10
Amp load. ( Refer to Wiring Diagram for
access to electric components). Ensure
that all wire connections are firmly
connected and free of moisture.
• Your appliance is equipped with a spare
fuse. Contact Customer Service for step
by step instructions for replacement.
No heat from
grill
• Appliance is turned off.
• No power.
• Faulty controller or heating
element.
• Pellet hopper is empty.
• Turn on the appliance.
• Check for any tripped circuit breakers and
reset the breaker, if needed.
• Check for faulty or tripped GFI (Ground
Fault Interrupter) at the outlet. Reset the
GFI or replace, if needed.
• If breaker or GFI continues to trip, use
a different outlet on a separate breaker
circuit.
• Try another working appliance in the
outlet.
• Replace controller or heating element.
• Fill the hopper with wood pellets.
Circuit breaker
trips or fuse
blows.
• Another appliance is plugged
into the same circuit as the
grill (too many appliances
using the same circuit).
• Moisture or water in the
controller, cord connection or
outlet connection.
• Damaged or frayed cord.
• Damaged electrical
connection.
• Find another outlet on a separate circuit.
• Keep all connections dry and free from
moisture. DO NOT use this appliance in
the rain or when snow is falling.
• Turn the unit off, unplug the unit and check
the cord for damage. Replace, if needed.
• Replace controller .
Appliance does
not generate
enough heat.
• Appliance was not pre-heated
sufficiently or temperature was
set too low.
• Lid left open.
• Improper extension cord.
• Pellet hopper empty.
• Auger is jammed.
• Pre-heat for 15-20 minutes. Increase
temperature settings via controller.
• Close the lid.
• Use cord rated for outdoor use at 15
amps.
• Add pellets.
• Remove internal cooking components,
turn the unit on, set the temperature dial to
"SMOKE" and visually inspect the auger
inside the fire pot and inside the pellet
hopper. If the auger does not turn, contact
Customer Service for additional support.