dymax UVC-5, Руководство пользователя

Страница: 13 / 20

USE R GUI DE | UVC -5 CO NVE Y OR 12
openings are not covered. The lamp case can be
dismounted in order to facilitate lamp replacement.
To protect your employees: It is possible to
conduct the exhaust air of the device outside
using a suitable exhaust air hose. The
exhaust hose connection piece (accessory)
can be ordered from the manufacturer.
5. Commissioning
Figure 6.
Front Side of UVC-5 Conveyor System
-S1 Rocker switch transport belt On / Off
Mini UV dryer On / Off
-S2 Pushbutton UV lamp On
-S3 Pushbutton UV lamp Off
-S4 Rocker switch half/full power
-H1 Indicating lamp transport belt On
-H4 Indicating lamp half/full power
-R1 Potentiometer transport speed
-Z1 Runtime counter
-P6 Display transport speed
Figure 7.
Rear Side of the UVC-5 Conveyor System
Designation:
1. Connector plug with mains fuse
2. Lamp supply line
Before connecting the device, check
whether the data on the rating plate comply
with the supply voltage.
5.1 Switching on the system
Observe the safety instructions in this operating
manual!
•
Press the switch pos. 3 (conveyor on/off), the
belt is running and the fan of the lamp unit is in
operation.
•
Start the UV lamp by pressing the key pos. 4.
The lamp is switched on and the fan in the
ballast starts running.
•
After approx. 3 minutes, the lamp has reached
full capacity. The lamp is now ready for
operation. The desired power level can be
selected by means of the switch pos. 6 (0 = half
power, 1 full power).
•
Set the desired transport speed by means of
the potentiometer (pos. 1).
5.2 Switching off the system
•
Switch off the UV lamp by pressing the key
pos. 5. The lamp goes out and the fan in the
ballast is switched off.
•
The lamp unit needs approx. 5 minutes to cool
down sufficiently. You can switch off the system
by pressing switch 3 only after this time has
elapsed since there is a risk of heat accumulation.
5.3 Belt speeds
Figure 8.
Front Side of the Conveyor
The rotary potentiometer (R1) allows continuous
speed control. The transport speed (2 - 26 m/min) is
shown on the LCD - display (P6). It is recommended
to check the belt speed at regular intervals with an
appropriate measuring instrument.