USE R GUI DE
|
BL UE WAVE
®
A X -5 5 0
7
Figure 4.
Align Controller and Emitter
Figure 5.
Install 4 Screws
Figure 6.
Minimum Clearance
System Installation
System Assembly
The system includes two major parts, the Controller and the
Emitter. The two parts are shipped separately. To assemble the
two parts together, please follow the instruction below:
1.
Locate the 4 Screws to be used to assemble the Emitter to
the Controller.
2.
Carefully place the Emitter on a clean and flat surface. Align
the Controller and the Emitter as shown in Figure 4. Plug
the Controller into the Emitter.
NOTE:
Be careful to keep the glass at the bottom of the
Emitter clean. To avoid leaving fingerprints on the glass, do
not touch the glass with bare hands.
3.
Install the 4 Screws to secure the Emitter to the Controller.
Tighten snugly with appropriate screwdriver, failure to
install screws will leave the potential for poor electrical
grounding of the system.
NOTE:
All four screws MUST be installed to ensure proper
grounding of the system chassis.
WARNING!
The BlueWave AX-550 is designed and
certified to operate as instructed within this document.
Alteration of the system or its component installation
may pose a shock hazard.
System Cooling
The system can be used in various scenarios with additional
mounting fixtures or Dymax accessories. For example: on a
desktop with a Dymax stand, on a chamber, conveyer, etc. This
system should only be operated in a location that provides proper
cooling. Location requirements are as follows:
•
For proper cooling of the unit, upper intake and lower
exhaust must not be blocked.
•
Minimum clearance as shown in Figure 6.
•
Note that the lower exhaust may have one side blocked for
installations where two units are side by side. The system
will operate safely but run hotter.
Intake
requires
1" vertical
clearance
Minimum of
one side
open with 1"
clearance
