dymax ACCU-CAL, Руководство пользователя

Страница: 7 / 12

USE R GUI DE
|
ACC U- CAL ™ 5 0 R ADI OME T E R 7
Figure 3.
Radiometer with Detector
Figure 4.
Adapter Installation
Figure 5.
Attach Lightguide Adapter to Lightguide (Step 4)
Figure 6.
Face Plate
Operation
1. The ACCU- CAL™ 50 Radiometer may be used to
measure UV intensity from Flood Lamps or UV intensity
from the end of a 3-mm, 5-mm, or 8-mm lightguide used
with a Spot Lamp. For Flood Lamp use, attach the
Detector to the Radiometer as shown in Figure 3.
2. For Spot Lamp use, select an Adapter that matches the
size of the Lightguide that is installed on the Spot Lamp.
3-mm, 5-mm, and 8-mm Adapters are available.
Note: Lightguide Adapters are included in the spot
version (PN 39560) of the ACCU-CAL
™ 50 or available
separately.
3. Install the Lightguide Adapter on the end of the Detector
using the two, 2 mm screws provided.
4. Attach the Lightguide Adapter to the Spot Lamp
Lightguide by inserting the Lightguide into the
Lightguide Adapter until it bottoms out. Tighten the set
screw when the Lightguide is installed.
5. Press and release the On/Off Key on the Face Plate to
turn the Radiometer on and off.
6. Press and release the Light Source Key to select the light
source being measured. The different light source options
are:
• Flood Lamp - For use when measuring UV intensity of
a flood-lamp light source.
• 3-mm Lightguide - For use when measuring UV
intensity at the end of a 3-mm lightguide.
• 5-mm Lightguide - For use when measuring UV
intensity at the end of a 5-mm lightguide.
• 8-mm Lightguide - For use when measuring UV
intensity at the end of a 8-mm lightguide.
7. Press and release the Mode Key to select an operating
mode. The different operating modes are:
• Peak Intensity - Shows the highest UV intensity in
mW/cm
2
seen by the detector during the
measurement.
• Intensity - Shows the UV intensity in mW/cm
2
at the
detector during the measurement.
• Dose - Shows the total UV dose in mJ/cm
2
at the
detector during the measurement.