FS20W
10
液位传感器
Pay attention to:
1
）
Never add any corrosive liquid(such as sulfate, hydrochloric and other high corrosive
detergent) into solution tank, or the machine will be damaged severely.
2
）
After charging, power lock should be closed and remove the key, temporary charge can
not replace full charge, such operations can severely shorten the service life of the battery.
The charger and the battery are matched to use, do not use the non configuration charger,
so as not to cause damage to the battery.
3
）
forbidden to open machine under charge state, it will cause accident or damage the charger
4
）
To check the liquid level sensor in the recovery tank.
5
）
If any foreign body is wrapped around the liquid
level sensor, please remove it in time to avoid
affecting the work of the sensor.
6
）
to keep solution tank clean, debris falling into may
be blocked drainage system.
7
）
rubber adjustment will directly affect the effect of
suction water, keep the squeegee and floor 90
degree vertical, when rubber blade worn, by
adjusting the universal wheel knob of queegee,
keep squeegee maintain proper position with
floor.
If squeegee and floor not be in 90 degree position, it may
cause the middle of squeegee is with not good suction
water effect, meanwhile, two sides rubber blade contact
floor too much to excessive wear, or even cause two side
of front rubber dislocation.
squeegee
adjustment
L
Liquid level sensor
