D2366 GSM Radio Signal Analyser – Operation Manual – D2366-OPS2/EU/F10/v4 -
18
Battery and Charging
Before first use, fully charge the battery.
When charging, use only the supplied mains plug-top power supply.
A completely flat battery will recharge within 3 hours (typically 2 hours).
A fully charged battery will operate the test set for up to 12 hours.
The battery state may be read on the
Monitor
screen. See page 14.
When the charger is connected, the unit is always on and the On/Off button will not turn the unit
off.
When the charger is disconnected, the GSM radio signal analyser will automatically switch off
within one minute or after the preset time has expired.
If the GSM radio signal analyzer is left switched on and unused (no buttons are being pressed),
the unit will automatically switch off after a preset time to preserve the battery life. The preset
time may be changed in the
Setup
screen. See page 9.
The internal battery is a Solid Electrolyte Lithium long type that may be transported, charged and
used in any orientation. It should be protected from frost and temperatures above 40°C.
As with all rechargeable batteries, over several years, its capacity to store power will degrade. If
the operational life of the battery reduces below 1 hour, contact your supplier for replacement
information.
Do not
attempt to open the case or remove the battery.
