D2366 GSM Radio Signal Analyser – Operation Manual – D2366-OPS2/EU/F10/v4 -
4
Using the Radio Signal Analyser
Use the test set to do a site survey – see page 6.
1.
Charge the battery before use
Connect the aerial (see page 16).
To switch on the radio signal analyser, press
the On/Off button until the logo is shown.
2.
This is followed by the
Startup
screen (see
page 8).
This screen is shown for about 30 seconds
while the radio module is powering up.
3.
If a SIM is fitted that requires a PIN, this
screen gives the option to use the Saved PIN
or enter a new PIN (see page 7).
If not, the Main Menu screen will appear.
Once the Saved PIN is used or a new PIN is
entered, the Main Menu screen will appear next.
4.
MAIN Menu
(See page 8 for information).
Press the right button to select the
Survey
screen.
5.
SURVEY Screen
If Engineer mode is selected in Setup, the
following screen will appear.
If Surveyor mode is selected in Setup, the
following screen will appear.
(See page 11 for information)
Press the right button to start the survey.
The radio signal analyser will measure all
detectable cells.
Keep the aerial upright.
Do not move or touch the aerial.
The survey may take up to 3 minutes to
complete.
Shows number of cells detected
Press the down button to select the
Results
screen.
