Dyaco Sole Fitness 16008900880, Руководство пользователя

Страница: 30 / 42

28
Customer Service
1-888-707-1880
Email
:
customerservice
@
dyaco
.
ca
GENERAL MAINTENANCE
BELT & DECK
Your treadmill uses a very high-efficient low-friction deck. Performance is maximized when the deck is
kept as clean as possible. Use a soft, damp cloth, or paper towel, wipe the edge of the belt and the area
between the belt edge and the frame. Also, reach as far as practical directly under the belt edge. This
should be done once a month to extend belt and bed life. A mild soap and water solution along with a
nylon scrub brush will clean the top of the textured belt.
Allow drying before using.
BELT DUST
This occurs during normal break-in or until the belt stabilizes. Sometimes the black dust from the belt
will appear on the floor behind the treadmill; this is normal.
GENERAL CLEANING
(Use the service chart in manual to record your maintenance)
Dirt, dust, and hair can block air inlets and accumulate on the running belt. Please vacuum
underneath your treadmill on a monthly basis to prevent excess build-up of dirt that can get sucked
up and get into the inner workings under the motor cover. Every other month, you should remove
the motor cover and carefully vacuum out dirt and hair that may accumulate. UNPLUG THE POWER
CORD BEFORE THIS TASK.
BELT ADJUSTMENTS
Tread-belt Tension Adjustment - Belt tension is not critical for most users. It is very important, though, for
joggers and runners in order to provide a smooth, steady running surface. Adjustment must be made
from the rear roller with the M6 L Allen wrench (
105
) provided in the parts package. The adjustment bolts
are located at the end of the step rails, as shown in the diagram below.
Note
: Adjustment is through small hole in end cap.
Tighten the rear roller only enough to prevent
slippage at the front roller. Turn the tread-belt tension
adjusting bolts 1/4 turn each and inspect for proper
tension by walking on the belt and making sure it is
not slipping or hesitating with each step. When an
adjustment is made to the belt tension, you must be
sure to turn the bolts on both sides evenly, or the belt
could start tracking to one side instead of running in
the middle of the deck.
Note:
Adjustment is through small hole in end cap.
DO NOT OVERTIGHTEN
– Over tightening will cause belt damage and premature bearing failure. If you
tighten the belt a lot and it still slips, the problem could actually be the drive belt located under the
motor cover that connects the motor to the front roller. If that belt is loose, it feels similar to the walking
belt being loose. Tightening the motor belt should be done by a trained service person.