18
DXE-CW9S
-
Shielded Control Wire, 9
conductor stranded, per foot
DXE-CW9S is a high quality shielded outdoor cable. It features 9 #24 AWG stranded conductors with
aluminum foil shielding plus a #24 stranded tinned copper drain wire. This gives you 8 switch positions plus
common ground - plus the separate shield. It has a gray PVC jacket.
This cable is ideal for DX Engineering
Remote Antenna Switches and Four Square arrays, and should be considered for any low-current custom
remote switching application you have - such as receiving antenna arrays. Order by the foot in the length you
require. Price shown is per foot. A nice feature is the "rip cord", which allows for easy stripping of the heavy
jacket without worry about nicking or accidentally cutting the conductors.
COMTEK Control Wire, 3 Conductor, Sold per Foot - COM-CW3
A high quality, PVC jacketed
3
-wire control cable, COM-CW3 consists of 3 #20 AWG conductors. It may be used in a
multitude of control cable applications, such as remote switching and antenna rotators.
Sold by the foot - order the length you need.
COMTEK Control Wire, 4 Conductor, Sold per Foot - COM-CW4
A high quality, PVC jacketed 4-wire control cable, COM-CW4 consists of 4 #20 AWG conductors. It may be used in a
mulititude of control cable applications, such as remote switching and antenna rotators.
Sold by the foot - order the length you need.
DXE-F6-1000 - 75-ohm F-6 Style Direct Bury Coax, 1000 ft. Spool Hi Quality, 75-ohm F6 type "Flooded" Coax
Sold by
the spool, or as Custom Cable Assemblies
Center Conductor:
18 AWG Copper-Clad Steel , Nominal Diameter: 0.040 in.
Dielectric:
Gas Expanded Polyethylene, Nominal Diameter Over Dielectric: 0.180 in.
Shield:
1st Shield: Aluminum-Polypropylene-Aluminum, Laminated Tape with overlap Bonded to the Dielectric,
Nominal Diameter Over Tape: 0.187 in. 2nd Shield: 34 AWG Aluminum Braid Wire, 60% Coverage
Jacket:
PE (Flooded for Underground), Nominal Diameter Over Jacket: 0.272 in. , Nominal Jacket Thickness: 0.030 in.
Electrical Properties:
Impedance: 75.0 +/- 3.0-ohms, Velocity of Propagation: 85.0% Nominal
We recommend the use of Snap-N-Seal connectors to ensure a high quality and weather resistant feedline connection. The
proper tool must be used to install these connectors.
DXE-CPT-659 - oax Cable Stripper for CATV F-6, RG-6 and RG-59 coax
Prepares CATV F-6, RG-6 and RG-59 coax cable for the installation of an "F" type connector.
One-step cutting motion
Precision cut
No nicks or scratches to conductor
Includes 1 replacement blade
DXE-RTV598335 - Permatex Black RTV Sealant, Non-Acetic - 3.3 oz Tube, Black
DX Engineering Approved RTV Sealant -
We have all used RTV to seal water out of things, right? Have you ever sealed a piece of
electronic gear with it -- then opened it some time later to find that it had still managed to become corroded inside?
Guess what? It's not the rain that corroded it - It's the RTV! Normal RTV gives off acetic acid when it cures. That's
the vinegar smell. The acetic acid causes the corrosion.
DX Engineering has located a Neutral Cure RTV made right here in Ohio that is non-corrosive and is safe for sealing
those baluns and other electronic gear that are going to be out in the weather.
Applies just like "normal" RTV, dries in one hour and cures in 24 hours at 70 degrees F.
And it doesn't smell like vinegar!
3.3 oz. Tube - Black
*This part is classified hazardous and is limited to domestic UPS Ground shipping only
