DX Engineering DXE-60VE-1P, Руководство пользователя

Страница: 8 / 23

- 7 -
Radial Plate to Mounting Pipe
Install the optional patented DXE-RADP-3 Radial Plate on the 2" OD ( maximum ) mounting pipe
using an optional DXE-SSCV-2P V-Bolt Saddle Clamp as shown in Figure 1 . Mount the radial
plate so you have approximately 1" of space between the bottom of the plate and the ground level.
This will allow easy access to install the radial wire hardware. The
DXE-RADP-3 Radial Plate
comes with 20 sets of stainless steel hardware for mounting the radial wires. Mount the plate as
shown in relation to how the Tilt Base. For reference,
Figure 7 shows a completed assembly.
Figure 1 - DXE-RADP-3 Radial Plate Installation
Attaching Ground Radial Wires to the Radial Plate
Using the 20 sets of supplied 1/4" stainless steel hardware (Bolt, Star Washer, Flat Washer, Split
Washer, Hex Nut) connect the
optional ground radial wires to the DXE-RADP-3 Radial Plate as
shown in Figure 2 . Additional hardware kits are available ( DXE-RADP-1HWK ) that contain 20
sets of Radial Plate Hardware.
Depending on the number of radial wires used, space them out evenly around the Radial Plate. The
Radial Plate will accommodate up to 60 radial wires (60 laser drilled holes), or up to 120 radials if
doubled up.
Radial Wire
Pattern
Figure 2 - Radial Wire Hardware Installation