- 8 -
Using a felt tip pen, measure and mark each of the 36" element sections at 4" as shown in
Figure 4
.
Figure 4
Locate the eight Element Clamps. Refer to
Figure 6
for the placement of the different sized element
clamps. Slide the clamps over each element section before putting them together. Align the clamps
facing the same direction. For final assembly, all the clamps should be positioned close to the top of
each section and the body of the clamp should be positioned between the slits as shown in
Figure 5
.
Figure 5
Using
Figure 6
on the next page, start the assembly with the bottom 1-7/8" section. Insert the
marked end of the 1-3/4" section into the 1-7/8" section until the 4 inch mark is even with the top of
the 1-7/8" section.
Position an element clamp at the very end, but not hanging over. Make sure the body of the clamp is
positioned between the slits and tighten securely.
Repeat the procedure for the each of the sections using the element clamps as required.
