- 17 -
DXE-STPL - Radial Wire Anchor Pins, 100/pack - No need to bury your radials!
DX Engineering Radial Wire Anchor Pins are perfect for fastening radials below the grass line to eliminate the risk of damaging your
radials during lawn maintenance.
100 count - 6'' Pins
11-Gauge
DXE-STPL-100P
Radial Wire Anchor Pins, 100/pack
DXE-STPL-300P Radial Wire Anchor Pins, 300/pack
DXE-STPL-100BD - Radial Wire Staple, Biodegradable, 3", 100 pack
DX Engineering
DXE-STPL-100BD
is a 100-pack of 3”
biodegradable
anchors that are produced from recycled PLA
(Polylactide Resin). Depending on the weather conditions, they will degrade in about a year. They are easily installed and
will hold radial wires in place until lawn roots overtake them - and then disappear. Ecologically friendly!
SUM-900031 - Automatic Wire Stripper/Crimper/Cutter, 24-10 Ga.
Our DX Engineering wire stripper uses a spring-loaded design to make quick work of wires ranging from 24 to 10 gauge. Just insert
the wire, squeeze the handle, and listen for the click. That’s the sound of another perfect wire stripping job performed
in about 2 seconds- a fraction of the time it takes your pocket knife to do the same job. An adjustable wire length guide
helps you make uniform strips, and a built-in wire cutter and crimper helps you complete your wiring job.
Spring-loaded design
Strips wires ranging from 24 to 10 gauge
built-in wire cutter and crimper
DXE-112-KIT - SO-239, Chassis Mount Socket, Silver Plating, Teflon Insulation
Chassis mount SO-239 with Silver plating and Teflon insulation for high power situations.
Packaged with the correct stainless bolts, flat washers, star washers and Nyloc locking nuts.
Silver plated
Teflon insulated
Stainless steel hardware
Nyloc nuts
DXE-8X19-RT - 19 inch "Pigtail" Terminals to PL-259
This cable makes connecting your vertical antenna to 50 Ohm coax easy! Utilize this pigtail with a
DXE-363-SST
bulkhead connector to mate the pigtail to your feedline. Done! The pigtail and bulkhead connector are ideal for use
with the
DXE-RADP-3
Radial Plate. This pigtail is not required if you order the optional
DXE-VFCC-H05-A
Vertical
Feedline Current Choke for connection to the base of the vertical antenna.
DXE-363-SST - Bulkhead Fitting, SO-239 Socket, Silver Plating, Teflon® Insulation
This high quality bulkhead connector uses silver plated outer and inner conductors and a Teflon® insulator. The
connector has very low loss and high electrical break down. It comes with two nuts to secure the connector to our
Radial Plate or other flat surface.
Perfect for use with the DX Engineering
DXE-RADP-3
Radial Plate it ensures the
radial system, the antenna ground and the feedline shield are common. It can also be used in other coaxial applications
where the male ends (PL-259) of 2 coax cables need to be connected, such as when joining two pieces of coax together.
Silver plated
Teflon® insulated
Very low loss
High electrical break down
2 in. long
This connector is
not
required if you order the optional
DXE-VFCC-H05-A
Vertical Feedline Current Choke for connection to the
base of a vertical antenna.
