17
To enter data for a register that cannot be measured by the hood use the “Manually
Enter Data” in the slide out menu. A register needs to be selected to enter data
manually.
If a register is selected and “Manually Enter Data” is pressed, then a dialog will appear
that allows for a value to be entered for the register.
Once all of the registers have been measured, the
NEXT
button at the bottom will
become enabled. Press and hold that button until the balance method selection screen
appears.
Select a balancing method.
Pressing on the
EXPRESS
button starts the Express balancing method, which starts
with the Place the Smart Hood dialog box. As shown in the below example, the app
will direct you to the register to measure:
Press and hold the
OK
button to bring up the dialog box asking to confirm that the
hood is correctly placed.
If the
YES
button on the hood placement confirmation dialog was pressed then the app
will bring up the Adjust to Target screen.
Touch to close the
dialog and set the
register’s value
Touch to close the
dialog and take a
pre-adjust reading
Touch to close
the dialog without
storing the reading
