DWT 740001, Оригинальное руководство пользователя

Страница: 23 / 157

22
English
Switching off:
Push the back part of on / off switch 6�
Design features
of the power tool
Speed selector thumbwheel
[WS08-115 V, WS08-125 V]
Using revolution adjustment switch 8, you may select
the required spindle speed (also during operation)�
The required speed is dependent on the material and
can be determined with practical trials�
When operating your power tool at a low speed for a
long time, it has to be cooled down for 3 minutes� To
do it, set a maximum speed and leave your power tool
to run idle�
Recommendations
on the power tool operation
Cutting (see fig. 6)
•
Install cutting disc as described below�
•
Start the power tool, wait until the engine gains its
maximum speed and only after that, smoothly bring
cutting disc to the surface processed�
•
Do not apply excessive pressure to the power tool,
as it will not bring better results but it will overload the
engine and wear out cutting disc faster�
•
Move the power tool along the cutting line with mod-
erate feed, not distorting and not making vibrating and
bursting movements�
•
Cutting should be implemented in the direction
shown on fig. 6. When cutting in the reverse direction
the danger of uncontrolled throwing of the power tool
out to the side of the operator, which can lead to seri-
ous injuries appears�
Grinding (see fig. 6)
Grinding is applied for the rough and quick grinding of
metals, the processing of welding seams, etc� Select
the type of grinding disc depending on the work, which
you are going to implement�
•
Install grinding disc as described above�
•
Start the power tool, wait until the engine gains its
maximum speed and only after that smoothly bring
grinding disc to the surface processed�
•
Holding the power tool at an angle of 10° to 15°
relating to the surface processed (see fig. 6) is rec
-
ommended� If this angle is less than recommended,
it will make controlling the power tool more difficult. If
this angle is more than recommended, the processing
quality will decrease and grooves will be left on the
billet surface�
•
Make alternate-reciprocal movements applying
moderate pressure to the power tool� Excessive pres-
sure will not bring better results but it will overload the
engine and create the danger of destruction of grinding
disc, which can cause severe injuries�
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains
�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� During the
long treatment of metal, current-conducting dust can
be accumulated inside the power tool. Regularly flush
the power tool with compressed air thought the ventila-
tion slots
3
�
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under:
www.dwt-pt.com
�
•
Transportation
of the power tools
Categorically not to drop any mechanical impact on
the packaging during transport�
•
When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Environmental
protection
Recycle raw materials instead of
disposing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly
recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
The manufacturer reserves the possibility to introduce changes.
Autogoods “130”
130.com.ua